Comment on page
Upgrade Instructions
Enzoic for Active Directory v3.3
Upgrading from an older version to the current release is straightforward and only involves running the installer for the current release on each domain controller in the monitored domain. A reboot will not be required after upgrading, unless upgrading from a version older than 2.0. It is safe to upgrade from any previous version to the current release.
Links to download the most current version (Domain Controllers must all run the same version):
Server Installer for Domain Controllers (must be installed on all domain controllers):
https://cdn.enzoic.com/files/EnzoicForAD.msi
MD5: 14c0728e5274f967f5f2a548ab3c0190
Client Installer (optional, see Client Setup Instructions for more details):
https://cdn.enzoic.com/files/EnzoicForADClient.msi
MD5: 4ba8f3f7d2f34642b74c42e0f7339a49
Enzoic for Active Directory needs to be upgraded on every writable domain controller in the target domain. In organizations where upgrading all servers at once is not possible or permitted, rolling upgrades over longer periods of time are supported. The only restriction is that the server designated as the Enzoic for Active Directory Delegate server in your domain must be upgraded to the new version first. The installer will not allow you to proceed with the upgrade on other DC’s until the Delegate has been upgraded. If you are unsure which Domain Controller in your environment is acting as the Delegate, you may determine this by running the Enzoic Console, going to Settings and clicking on the “Other Settings” tab. The current Delegate will be displayed there.
Run the new installer on each DC in the monitored domain in order to upgrade it. As noted in the section above, you must run the upgrade on the Delegate server in your domain first. After the upgrade is complete, run the Enzoic Console and verify there are no issues displayed on the Dashboard or in System Health.